First RPF CPE Reference Design
page,page-id-16426,page-template,page-template-full_width,page-template-full_width-php,ajax_fade,page_not_loaded,,qode-title-hidden,qode-theme-ver-9.2,wpb-js-composer js-comp-ver-,vc_responsive


The Fastest Way to Get into With RPF into your CPE


The Sckipio CP1010R-EVM CPE Reference Design is a complete CPE solution including all the hardware and software needed to complete an end-to-end evaluation. The CP1010R-EVM implements a single FTU-R transceiver that complies with the ITU recommendations (G.9700/1).

CP1010R-EVM CPE Bridge

CP1010R-EVM CPE Bridge

The Sckipio CP1010R-EVM CPE Reference Design is available to help OEMs and ODMs add reverse power feed (RPF) injectors into their CPE designs and get to market with ultra high speed broadband for MDU, Single Family Units and businesses faster than any other way. It also is an excellent solution for cellular backhaul.


Broad Standards Support
  • Fully compliant with the ITU-T Recommendation (G.9700/1)
  • Supports the complete 106a profile
  • Support for ITU-T G.997.2
  • Support for IEEE 1588 Time Synchronization
  • Supports ITU G.994.1 G.hs
  • Spectrally co-existent with legacy technologies, e.g. ADSL, VDSL
Full Performance
  • Bandwidth: 2 – 106MHz (programmable)
  • Max PHY rate: 1Gbps per line
  • Flexible downlink/uplink bit rate ratio
Highly Efficient Design
  • Single Port Digital Front End
  • Analog Front End with integrated line driver
  • All “on-chip” memory
Low Power Consumption
  • Average active end-to-end transceiver power of <2 watts
  • Low power modes supported across the whole reference design (DFE and AFE)
  • Multiple power save modes lowering actual consumption under real life conditions
  • Full discontinuous mode support for lower actual consumption under real-life conditions
  • Support for L2.0, L2.1 low power states
  • Robust with high immunity to disturbers
  • Fast Online Reconfiguration (OLR)
  • Fast train/retrain time
  • Flexible DTU size
  • 100/1000BaseT
  • MDIO management master and slave with Clause 22 and Clause 45 support
  • Ethernet MAC and PHY mode support
Time and Synchronization
  • Time-of-Day (ToD) synchronization to external clock reference
  • Synchronization using low accuracy management protocol, IEEE 1588 or one PPS signal
  • 8KHz Network Time Reference (NTR) support between DP and CPE
Management and Configuration
  • Configuration interface for customized functionality
  • Upgradeable firmware
  • Full performance monitoring
  • Full development system and reference design for fast time-to-market
  • Includes reverse power feed (RPF) injector to bridge design